PUSH BUTTON RINSE TANK TIMER is suitable for repetitive process timing. It has a relay output to control devices like solenoid valves. Two independent timer cycles up to 99 minutes each. Waterproof and corrosion proof. Perfect for plating processes.

A Better Rinse Tank Timer ...

• Loud warbling alarm easily pierces through the loudest loud industrial plant noise.

• Waterproof. All parts are NEMA 4X rated. Built for rugged industrial service.

• Relay output 15A will control 1/2 HP motors, solenoids, heaters.

• Time is easily adjustable from 1-99 seconds or 1-99 minutes using discrete position rotary switches.

• Low profile - button extends out from tank only 85 mm. (3.3")

• Rinse control with a timer is easier and more reliable than with a conductivity controller.

TIMER MODELT2

Rinse Tank Timer model T2 has a 15A relay output. Two time cycles are independently settable. Each can range from 1 second to 99 minutes.

Typical Operation
At the end of the first time cycle, when a load should be removed from a rinse tank for example, the illuminated push button flashes and the audio buzzer sounds. When the button is pushed to silence the alarm, the second time cycle from 1sec-99min starts. The second time cycle can open a solenoid valve to control rinse water flow. When the second time cycle is complete, the buzzer sounds briefly.

Alternate Operation Mode
The first time cycle could be used to prepare the tank by turning on a heater to warm it up, or to dose chemicals by turning on a pump. When the first time cycle has elapsed and the rinse is prepared, the buzzer sounds until acknowledged. This is a cue to run work thourgh the tank. At the end of the second time cycle the buzzer sounds again.

TIMER INCLUDES 10 FT PIGGYBACK CORD

Construction
Timer model T2 is enclosed in a PVC box 4 x 4 x 2" with stainless steel screws. Rated NEMA 4X - suitable for washdown duty. The compact box can be either screwed in place.

The buzzer is 103dB and has a warbling tone that pierces through loud ambient noise. Stainless steel transducer can get wet.

Relay Output
The 15A relay controls pumps and solenoids using a convenient piggyback plug. The piggyback plug on the end of a 10 foot cord makes installation simple. Your pump or solenoid can plug into the female end and no further wiring is necessary. The T2 timer switches your devices on and off according to the time cycle. more on piggyback plugs.

OPERATING MODES

Setup
The operation mode is chosen with dip switches. (see chart above)
The time is set with intuitive rotary switches to the precise time. No guessing with potentiometers. Once the time is set, just close the cover and it can't be tampered with.

SETTING THE TIME

Questions?

Phone 585-301-0970
email: peter@drumalarm.com

ORDER HERE

Timer T2 $185