 |
|
|
 |
|
|
 |
|
|
|
The IBC TANK LEVEL ALARM is supplied with a cap to fit an intermediate bulk container. (tote tank) Liquid is fed to your process through a tube and flowmeter. When liquid level gets low, a bright flashing LED and a loud beeper alerts. Never run empty again!
|
|
|
|
 |
|
Better Liquid Level Control...
- Always on duty because the liquid tube is permanently attached to the alarm unit.
- It can go anywhere because its battery powered. No need for power outlets.
- Uninterruptible battery power lasts for years. Lithium battery included.
- Loud warbling tone cuts through the loudest industrial noise.
- Rugged. Built for rough, wet and corrosive environments.
- Protects your pumps from debris with an intake screen.
- Flow indicator built into low level units.
- Safe. 9 volt circuit in a waterproof enclosure.
|
|
|
 |
|
|
|
330 GALLON TOTE TANK
|
|
|
|
 |
|
|
|
OVERALL VIEW
|
|
|
|
|
|
POLYPROPYLENE MODEL DLI-50-PP
|
|
|
|
Some chemicals commonly used with these level alarms:
- Aqueous Ammonia (conc.)
- Aqueous solutions.
- Chromic acid (50%, Rm. Temp)
- Glycolic acid
- Hydrochloric acid (conc.)
- Nitric acid (30%)
- Oils (including waste oils)
- Potassium carbonate (40%)
- Polyester resin (viscous)
- Sodium hydroxide (50%)
- Sulfuric acid
- Sodium Hypochlorite
The following chemicals not compatible with the acrylic flowmeter:
- Sulfuric Acid 98%
- Lactic acid
- Phosphoric acid
CLICK FOR CHEMICAL RESISTANCE CHART
|
|
|
IBC TOTE TANK ALARM for low liquid level makes sure your process will never run out of chemicals. When liquid level is low, an IBC Alarm emits a very loud 103dB beeping sound, and flashing LED.
|
|
|
|
Uninterruptible battery power works through power failures, can't come unplugged, or be defeated. And, because the Drum Alarms don't use any power until alarming, the batteries last for years.
|
|
|
 |
|
|
|
|
Float switch is protected inside a pipe. The float is immune to abuse from getting knocked around during transfer between containers. Year of reliable service.
Adjustable depth to fit any size tote tank. Simply loosen the set screws to slide pipes to correct depth up to 50 inches. (this is slightly deeper than a standard 330 gallons Mauser IBC tank which is 48.5")
The the feed tube is permanently attached to the float switch, so the level alarm is always on duty.
|
|
|
|
|
|
|
|
 |
|
|
Removable filter screen on the suction pipe guards your pumps from debris or crystals. A replaceable check valve can be easily inserted in-line to prevent liquid from draining when transferring to new containers if needed.
|
|
|
|
 |
|
|
|
REMOVABLE SCREEN
|
|
|
|
Different materials for different chemistries: PVC, polypropylene. Both constructions have no wetted parts and are ruggedly built for industrial environments.
PVC models have a polypropylene float switch with PVC piping.
Polypropylene models also have polypropylene floats, and also polypropyelene piping so all wetted parts are polypropylene Except the Acrylic flowmeter. This can be upgraded to PMP which has properties similar to polypropylene if necessary.
|
|
|
|
 |
|
|
|
NO FEED PIPE - TLI-50-PP
|
|
|
|
SPECIFICATIONS
GENERAL
- Maximum working depth.................................. 50 inches
- Total depth including electronics enclosure......56 inches
- PVC enclosure rating ............................ NEMA4X / IP65
- Buzzer volume.............................................103dB @ 2ft
- Current during alarm...............................................30mA
- Lid (IBC lid crawing) .......polypropylene, 6" buttress
- Battery capacity..............................................1250mA-hr
- Suction screen.......................polypropylene, 420 micron
OPTIONAL PCB
- Relay mode................................. selectable N.O or N.C.
- Relay output.......... 16A@277VAC Panasonic ADJ23005
- Power cord.................................SJOOW jacket, 3 x14ga
- Quiescent current:................................................. 32 uA
- Slosh time delay:..............................................500 msec
|
|
|
|
|
PVC PIPE MODEL DLI-50
|
|
|
|
|
 |
|
|
|
ORDER HERE
Model TLI or TLI-PP No Feed Pipe
|
|
|
ORDER HERE
Model DLI PVC piping, polypropylene float switch $249
|
|
ORDER HERE
Model DLI-PP Polypropylene piping and float switch $289
|
|
|
|
|
 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Questions?
Phone 585-301-0970 email: peter@drumalarm.com
|
|
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |